|
|
nautavac's
auto and home upholstery cleaner is an excellent
product for cleaning your favorite chair, the couch you can't wait to get
home to or the front seat of your car where junior dropped his ice cream.
- Before using, test on a hidden area for color fastness. DO NOT
use this product on oriental rugs, velvet or Indian cotton.
- To prepare the solution, add 2 ounces to each gallon of hot water
(never use boiling water), or 4 to 6 ounces to the solution
tank.
- For heavily soiled areas, pre-treat with nautavac
Prespotter.
- Using the hand tool, mist the area to be cleaned using caution as
not to over wet, then vacuum up dirt.
- Wipe overspray immediately from wood or glass as some etching may
occur.
Back to Chemical Page
|
|
|
nautavac's
Prespotter is a concentrated liquid
degreaser specifically formulated to loosen ground in dirt on high traffic
areas of your carpet.
- When using this product, add 4 capfuls of Defoamer
to the recovery tank. Remember to add each time you empty the
recovery tank.
- Hold prespotter bottle approximately 10 to 12 inches from area to be
treated.
- Spray a mist over the area.
- Let sit 10 to 15 minutes.
- Then clean using the nautavac
carpet cleaning system.
Back to Chemical Page
|
|
|
nautavac's
Pet Stain and Odor Remover is an
enzyme based professional strength formula. It was specifically
developed to remove pet stains and odors including vomit and urine from
carpets, upholstery, concrete, tile and wood.
GENERAL INSTRUCTIONS
- Shake well before using
- DO NOT mix with boiling water, disinfectants or bleach.
- Test on a hidden area for color fastness.
There are two ways to use this product.
-
To use as a stand alone stain remover:
- Remove any solid waste
- Apply full strength until surface is saturated.
- With a clean damp white cloth, gently work the affected area, always
working inward as not to spread the stain or odor into unaffected
areas.
- Let sit for a minimum of 20 minutes.
- Blot with clean white cloth to pick up excess liquid.
- Rinse area with clean water and blot dry.
- Repeat daily until odor is gone, always finishing with a clean water
rinse.
-
To use with nautavac
carpet cleaning equipment:
- Use full strength, pour full bottle into solution
tank.
- When using this product, add 4 capfuls of Defoamer
to the recovery tank. Remember to add each time you empty the
recovery tank.
- Clean the affected area by spraying the solution enough to penetrate
the surface while at the same time vacuuming up any stain or dirt.
- Let sit for 20 minutes.
- Fill solution tank with clean water and rinse the area you just
cleaned and vacuum dry.
Return to Chemical Page
|